Micro-Machinability Studies of Single Crystal Silicon Using Diamond End-Mill

Choong, ZJ; Huo, D; Degenaar, P; O'Neill, A

doi:10.1115/MSEC2016-8622

Micro-Machinability Studies of Single Crystal Silicon Using Diamond End-Mill

Lookup NU author(s): Dr Zi Jie Choong, Dr Dehong Huo, Professor Patrick Degenaar, Professor Anthony O'Neill

Downloads

Full text for this publication is not currently held within this repository. Alternative links are provided below where available.

Abstract

This paper presents the research on the machinability studies in micro-milling of (001) silicon wafer. Excessive generation of undesirable surface and subsurface damages such as surface edge chipping often occurs when machined at depth of cut of several hundreds of microns. Ideal machining strategy to reduce the generation of edge chipping is required. Investigations on the effect of machining conditions on the cutting performances and size effect on the specific cutting energy in silicon micro-milling were conducted. These investigations provide understandings on the behavior of cutting mechanism during machining and helps to identify suitable machining parameters for fracture free machining using diamond end mills. Full slot milling were performed along <100> and <110> directions on a (001) surface wafer under various machining conditions. Results show that machined surfaces along <100> were of better quality than those along <110> and is in agreement with previous studies. Furthermore, good machining quality was achieved when machined at depth of cut of 10 pin or feed per tooth of 0.075 mu m/tooth, regardless of the machining conditions. In addition, investigation for the size effect on specific cutting energy also shows that brittle mode machining begins when feed per tooth increases beyond 0.4 mu m/tooth.