Lookup NU author(s): Professor Keith Scott,
Dr Mohamed Mamlouk
Full text for this publication is not currently held within this repository. Alternative links are provided below where available.
A steady-state, isothermal, one-dimensional model of a direct methanol proton exchange membrane fuel cell (PEMFC), with a polybenzimidazole (PBI) membrane, was developed. The electrode kinetics were represented by the Butler-Volmer equation, mass transport was described by the multicomponent Stefan-Maxwell equations and Darcy's law, and the ionic and electronic resistances described by Ohm's law. The model incorporated the effects of temperature and pressure on the open circuit potential, the exchange current density, and diffusion coefficients, together with the effect of water transport across the membrane on the conductivity of the PBI membrane. The influence of methanol crossover on the cathode polarization is included in the model. The polarization curves predicted by the model were validated against experimental data for a direct methanol fuel cell (DMFC) operating in the temperature range of 125-175 degrees C. There was good agreement between experimental and model data for the effect of temperature and oxygen/air pressure on cell performance. The fuel cell performance was relatively poor, at only 16 mW cm(-2) peak power density using low concentrations of methanol in the vapor phase.
Author(s): Pilditch S; Scott K; Mamlouk M
Publication type: Article
Publication status: Published
Journal: Journal of Fuel Cell Science and Technology
Print publication date: 01/10/2013
Online publication date: 20/08/2013
Acceptance date: 05/10/2012
ISSN (print): 1550-624X
ISSN (electronic): 1551-6989
Altmetrics provided by Altmetric