Lookup NU author(s): Professor Keith Scott
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License (CC BY-NC 4.0).
A three layer membrane (TLM) of polybenzimidazole/graphiteoxide/polybenzimidazole (PBI/GO/PBI) has been fabricated as an electrolyte for intermediate temperature polymer exchange membrane fuel cells (IT-PEMFCs). The membrane is prepared by encapsulating a GO layer with two single PBI membranes via a layer-by-layer procedure and subsequently imbibed with phosphoric acid (PA). The TLM exhibits a lower swelling ratio than that of the pristine PBI membrane at the same PA loading time. The mechanical strength of the TLM could reach 28.6 MPa at 150 degrees C, significantly higher than that of a PBI membrane (12.2 MPa). The TLM is loaded with a PA amount of 2.23H(3)PO(4) molecules per repeat unit (PRU), which provides a proton conductivity of 0.0138 S cm (1) at 150 degrees C. The three layer structure promotes a membrane for PEMFCs with lower PA leakage and material corrosion. The fuel cell performance based on TLM exhibits a peak power density of 210 mW cm(-2) at 150 degrees C.
Author(s): Deng YM, Wang G, Fei MM, Huang X, Cheng JG, Liu XT, Xing L, Scott K, Xu CX
Publication type: Article
Publication status: Published
Journal: RSC Advances
Online publication date: 05/07/2016
Acceptance date: 27/06/2016
Date deposited: 04/11/2016
ISSN (electronic): 2046-2069
Publisher: Royal Society of Chemistry
Altmetrics provided by Altmetric