Toggle Main Menu Toggle Search

Open Access padlockePrints

Investigation into the effect of cutting fluid concentration on the machinability of Ti-6Al-4V using vegetable oil-based cutting fluids

Lookup NU author(s): Dr Islam Shyha, Dr Dehong Huo

Downloads

Full text for this publication is not currently held within this repository. Alternative links are provided below where available.


Abstract

This paper describes experimental results when turning Ti-6Al-4V using water-miscible vegetable oil (VOs)-based cutting fluid. The effects of cutting fluid concentration and machining conditions on average surface roughness (Ra) and micro-hardness were evaluated. L27 fractional factorial Taguchi array was utilised. This study found that a combination of VOs-based fluid concentration (10%), high cutting speed (146 m/min), feed rate (0.1 mm/rev) produced the lowest average surface roughness (Ra). However, 10% concentration showed a marginal improvement in Ra compared to 5%. Cutting fluid concentration is a significant factor for reducing Ra.


Publication metadata

Author(s): Gariani S, Shyha I, El-Sayed MA, Huo D

Publication type: Article

Publication status: Published

Journal: Journal of Engineering Technology

Year: 2017

Volume: 6

Issue: 2

Pages: 414-423

Print publication date: 28/07/2017

Acceptance date: 28/07/2017

Date deposited: 16/01/2018

ISSN (print): 0747-9964

Publisher: American Society for Engineering Education

URL: https://www.engtech.org/jet/


Share